+86-596-7022710     
www.xhc-accessories.com
You are here: HOME » News » Knowledge » How to Use a Plywood Glue Mixer

Latest News

Contact Us

 
Fujian Zhangzhou, Xintai Industrial Park, Changtai Economic Development Zone, Zhangzhou, Fujian, China
 
 
+86-596-7022710
 

How to Use a Plywood Glue Mixer

Views: 7     Author: Site Editor     Publish Time: 2021-01-04      Origin: Site

If you are into contracting and manufacturing wooden objects, then the Plywood Glue Mixer is the best tool for you. This is the most essential equipment to get the type of surface you want to produce. It has been used for many types of wood products. Read this article below for more information about the Glue Mixer.


One time: Before you make any move or mix up anything on your workbench or machine, you need to ensure that the ingredients are mixed well and thoroughly. The high-speed mixing wheel is very useful here. It can easily mix the raw materials to the desired consistency and strength. One drawback is that the particles may fall down the chute and can damage some surfaces when coming in contact with too much heat. The comma also can break down when heated.


Two times: The second step of the process involves putting the raw materials and the cement or adhesive in a container and raising or lowering it using a hydraulic lifting glue mixer. To do this, you have to be careful enough while mixing the ingredients. The ingredients can burn each other, the cement or adhesive can melt, and you have to carefully put them in the containers and lift or lower them at the right temperature. If not done properly, the mixture will fall and burn. The best way to do this is to put the containers on one side of the mixing drum and the ingredients and adhesive on the other side.


Three times: It is possible to use a plywood glue mixer machine to speed up the bonding process, especially when mixing a very stiff type of paste or varnish. This method usually produces longer lasting and more consistent results. The most common use of this device is for wet mixtures. For instance, if you are mixing paints and are using an airless mixing apparatus, the mixing would take a lot longer than it would if you used a conventional mixing apparatus. However, the disadvantage of using a conventional mixing apparatus is that it can break or damage the material you are working on. If this happens, the job becomes more difficult and it may be needed to start all over again.


Four times: The fourth step to using a plywood glue mixer machine is to turn off the power. When you are done mixing all the ingredients and putting them into the containers, you can close the lid and leave it aside for an undetermined period of time. You can open the lid when the paste is dry. However, make sure that you don't open the lid too early as the paste could burn if left in place for too long. If you feel that the ingredients are too wet or the mixture is too loose, immediately switch off the power to your vertical glue mixer.


5. Increase the frequency and the intensity of mixing: You can increase the frequency and the intensity of your mixing by adjusting the rotation speeds and the transfer speed of the motor. The appropriate setting of these elements can determine the quality of the finished paste. In addition to improving production capacity, a greater frequency in mixing means reduced cost, and you can experience significant cost savings.

Copyright © 2024 MUZHIYUAN IMP&EXP All rights reserved.